When constructing titanium tubes and titanium alloy tubes, the general operation is as follows:

    1. Titanium alloy pipe elbows should be inspected on time. The surface must be cleaned, dirt removed, and stored in a place where the air is monotonous in the room. It cannot be stacked or stored in the open air.

    2.The ball valve of the titanium alloy pipe elbow, the blocking valve and the gate valve are only fully open or fully closed, and are not allowed to adjust the flow rate, suppress the erosion of the sealing surface and accelerate the wear.

    Titanium ，titanium alloy pipe installation titanium and titanium alloy pipe transport and storage when the titanium pipe manufacturers should pay attention to contact and collision with iron materials.

    1. The cutting of titanium and titanium alloy tubes should be mechanical. The cutting speed should be low speed. When cutting or grinding the titanium tube with grinding wheel, special grinding wheel should be used; flame cutting should not be used. The groove should be machined.

    2. .Titanium and titanium alloy tubes should not be directly welded to other metal pipes. When a connection is required, a loose flange connection can be used. The non-metallic gaskets used are generally rubber mats or plastic mats, and the chloride ion content should not exceed 25 ppm.